A
fine, clean, accurate depth of cut is achieved by software controlled
adjustment of both the cutting speed and the power output of the laser
cut. The control of cutting is so accurate, you can even etch onto paper.
A cross-flow extraction system draws away the fumes by sending a flow
of air across the bed during cutting. To achieve a clean cut edge, an
irrigation system is attached to the cutting head which sends a stream
of air or inert gas to the point of cut.
The FB Laser Cutting Systems use sealed CO2 water cooled lasers and
are certified Class 1 laser products, being interlocked and fully enclosed
while cutting.
Clean,
accurate cutting can be achieved on a wide range of materials including:
